B

Can't use Bilstein factory shocks - the shocks are too long and the coils will fall out. Our shocks part #2050 must be used with a light duty coil (without the shock extenders) or a heavy duty factory shock must be used with our shock extenders part #33070.

BJ

Our part uses your original style ball joints.

BL

S10 kit works on the S-10 blazer too.

BS

Kit includes new bump stops for the rear.

C

Kit includes ball joint spacers without any flipping so that 16" or larger rims can be used. You can only use these spindles on coil spring fron end, 2WD, 1/2 ton Cheyv or GMC Trucks.

C2

If your Ford has a two piece drive-line, you may need a carrier bearing relocator.

CB

if your truck has a two piece drive-line, you may beed a carrier bearing relocator.

CS

Our A-Frames use your original cross shafts.

DB

Must convert from original drum brakes to disc brakes.

E

May need to re-route exhaust from more clearance.

EX

Must use shock extenders with this kit.

FL

our lowering kits will not work with factory lowered Colorado or Canyon Trucks.

HD

Must use heavy duty disc brakes (1.25" Thick Rotors).

HS

Our coils are meant to be used with the factory heavy duty (3" Diameter) or auto leveling air shocks.

LD

Must use light duty disc brakes (1" Thick Rotors).

LS

Our coils are meant to be used with the factory light duty (2" Diameter) shock or our #2050.

OL

You must remove the factory over-load leaf to do this drop.

S

Must use shorter rear shocks.

SE

Our Part #33036 is recommended. They aren't required, but they do make a difference in the ride quality. The shock extenders relocate the shock angle to put it back to its original angle.

SR

Deluxe kit will not work on the Dodge SRT models. The ECONOMY KIT is recommended for the SRT.

SW

Disc brakes will not work with the original 1957-1964 14" wheels.

T

Must use 17" or larger wheels in order to use the spindles.

TR

Our part uses the original style tie-rods.

WH

The kit/hanger will not work on trucks with a 5'bed (which has a welded front leaf spring hanger) or the 8' bed (long bed). Must use a kit with a leaf spring instead of a hanger.

WT

2009 Ram 1/2 ton Spindles (Part #44001) increases the fornt wheel track by 3/8" per side.

V8

The coil springs were engineered for a truck wiht a V-8 engine. If coils are installed on a 6-cyl. truck then the full drop will not be achieved and the rear will sit lower than the front.

XL

Our kit will not work on the "XL" version.